Difference between revisions of "Zyxel"

Revision as of 18:06, 19 May 2013

Useful Zyxel P660 series modem commands, including changes to SNR targets and NAT loopback.

Accessing the modem command-line interpreter

Enter the command-line menu by telnet-ing to your modem's IP address and then, either:

menu item 24.8

or

directly with later modem versions.

To allow direct access to your external (WAN) IP address:

The steps below make the change permanent, although the command can equally be used at the normal ras> prompt which will survive until the next power-off/reboot:

sys edit autoexec.net
i
ip nat loopback on
x

To alter the ADSL target SNR:

wan adsl targetnoise [0xfa .. 0x06]

final number is in units of 0.5dB, so 0x06 is equivalent to a +3dB increase in the target (improved stability).

To disable rate adaption:

wan adsl rateadap off

To adjust the stale session timeouts:

sys tos timeout icmp 60
sys tos timeout udp 45

Note: these commands need to be put into the autoexec.net (note not autoexec.bat!) file in order to survive a power-off/reboot.

This website publishes a Privacy Policy. Continued use of this website implies your consent to the storage of data outlined in the policy.

@@ Line 3: / Line 3: @@
 <analytics uacct="UA-27654202-1" ></analytics>
-Enter the command line via menu item 24.8 or directly with later modem versions.
+== Accessing the modem command-line interpreter ==
+Enter the command-line menu by telnet-ing to your modem's IP address and then, either:
+* menu item 24.8
+or
+* directly with later modem versions.