Difference between revisions of "Zyxel"
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Useful Zyxel P660 series modem commands, including changes to SNR targets and NAT loopback. | Useful Zyxel P660 series modem commands, including changes to SNR targets and NAT loopback. | ||
| − | |||
| − | |||
== Accessing the modem command-line interpreter == | == Accessing the modem command-line interpreter == | ||
| Line 45: | Line 43: | ||
| − | This website publishes a | + | This website publishes a Privacy Policy (link at the bottom of every page). Continued use of this website implies your consent to the use of data outlined in the policy. |
| − | |||
| − | |||
| − | |||
| − | |||
Latest revision as of 23:35, 4 January 2019
Useful Zyxel P660 series modem commands, including changes to SNR targets and NAT loopback.
Accessing the modem command-line interpreter
Enter the command-line menu by telnet-ing to your modem's IP address and then, either:
- menu item 24.8
or
- directly with later modem versions.
To allow direct access to your external (WAN) IP address:
The steps below make the change permanent, although the command can equally be used at the normal ras> prompt which will survive until the next power-off/reboot:
- sys edit autoexec.net
- i
- ip nat loopback on
- x
To alter the ADSL target SNR:
- wan adsl targetnoise [0xfa .. 0x06]
final number is in units of 0.5dB, so 0x06 is equivalent to a +3dB increase in the target (improved stability).
To disable rate adaption:
- wan adsl rateadap off
To adjust the stale session timeouts:
- sys tos timeout icmp 60
- sys tos timeout udp 45
Note: these commands need to be put into the autoexec.net (note not autoexec.bat!) file in order to survive a power-off/reboot.
This website publishes a Privacy Policy (link at the bottom of every page). Continued use of this website implies your consent to the use of data outlined in the policy.